This puller has been especially developed for dismantling ball bearings fixed both in the housing and on the axle. Select the right arms (no 1.29/10-45) for the bearing to be dismantled and attach them to the ball race. Distribute the distance equally between the hooks against the outer rings inner edge. If the support ring is to be used this is fitted inside the arms on the inner bearing ring. The hooks are then fitted on the yoke and are clamped by means of the spindle.
No 1.29/2-5 are supplied with plug-in handle.
These pullers are used together with loose arm sets 1.29/10-45.